Citation: | WEN Jiakun, CAO Yuan, MA Lianchuan, et al., “Design and Analysis of Double One Out of Two with a Hot Standby Safety Redundant Structure,” Chinese Journal of Electronics, vol. 29, no. 3, pp. 586-594, 2020, doi: 10.1049/cje.2020.03.015 |
Y. Cao, T. Tang, T. Xu, et al., “Application of formal methods in train control system”,Traffic Transp, Vol.10, No.1, pp.112-126, 2010.
|
Y. Cao, L. Ma, S. Xiao, et al., “Standard analysis for transfer delay in CTCS-3”, Chinese Journal of Electronics, Vol.26, No.5, pp.1057-1063, 2017.
|
Y. Cao, L. Ma and Y. Zhang, “Application of fuzzy predictive control technology in automatic train operation”, Clust. Comput, at http://dx.doi.org/10.1007/s10586-018-2258-0,(2018).
|
Y. Sun, Y. Cao and M. Zhou, “A hybrid method for life prediction of railway relays based on multi-layer decomposition and RBFNN”, IEEE ACCESS, Vol.7, pp.44761-44770, 2019.
|
Y. Cao, Y. Sun, G. Xie, and T. Wen, “Fault diagnosis of train plug door based on a hybrid criterion for IMFs selection and fractional wavelet package energy entropy”, IEEE Transactions on Vehicular Technology(2019), doi: 10.1109/TVT.2019.2925903.
|
International Electrotechnical Commission. IEC Std 61508-1997 Functional Safety of Electrical/Electronic Programmable Electr-onic Safety-related Systems.
|
Y. Zhang, C. Hong, Y. Cao, et al., “Safety mechanism design and verification of safety computer parallel program”, Chinese Journal of Electronics,Vol.27,No.6,pp.1163-1169, 2018.
|
Y. Cao, Z. Wang, and F. Liu, “Bio-inspired speed curve optimization and sliding mode tracking control for subway trains”, IEEE Transactions on Vehicular Technology2019., DOI: 10.1109/TVT.2019.2914936
|
S. Du, L. Ma and Y. Cao, “Comprehensive analysis on safety and reliability of safety-related systems considering common cause failure”, International Conference on Control Automation and Information Sciences, pp.531-535, 2018.
|
Y. Cao, H. Lu and T. Wen, “A safety computer system based on multi-sensor data processing”, Sensors, Vol.19, No.4, 2019.
|
X. Cai and C. Wang,“Synchronization mechanism for double 2-vote-2 safety computer platform of on-board automatic train protection”, Computer Engineering, Vol.41, No.8, pp.301-305, 2015.
|
Y. Zhang, L. Zou, W. Wu and Z. Liao, “New degradation strategy of double 2-out-of-2 system”, Journal of East China Jiaotong University, Vol.34, No.5, pp.99-105, 2017.
|
B. Cai, C. Jin, L. Ma, et al., “Analysis on the application of on-chip redundancy in the safety-critical system”. IEICE electronics express, 2014.
|
A. Kawabata, N. Anzai, T. Kikuchi, et al., “Design of a SmallSized Interlocking System with High Availability”, Electrical Engineering in Japan, Vol.128, No.2, pp.63-73, 2015.
|
X. Chen, G. Zhou, Y. Yang, et al., “A newly developed safety-critical computer system for China metro”, IEEE Transactions on Intelligent Transportation Systems, Vol.14, No.2, pp.709-719, 2013.
|
J. Zheng, “Analysis of locomotive manipulation automatic optimization device based on double 2-vote-2 computer system”, Journal of Railway Science and Engineering, Vol.10, No.3, pp.112-115, 2013.
|
T. Huang, X. Chen and H. Huang, “Safety computer system based on 2 out of 3 redundant structure”, Computer Engineering, Vol.37, No.18, pp.254-257, 2011.
|
X. Sun, “Research and design of two out of three system about autonomic machine in CTC”,MA.Eng Thesis,Beijing Jiaotong University, China, 2018.
|
X. Li, B. Bai and J. Zhou, “Study on reliability of multiple modular redundant reconfigurable computer”, Computer Measurement & Control, Vol.25, NO.7, pp.309-312,316,2017.
|
S. Chen, D. Zhang, L. Ge, et al., “Research on reliable redundant structure in computer interlocking system”, Industrial Control Computer, Vol.29, No.8, pp.78-79,81, 2016.
|
Y. Li, “Research on international standards of functional safety”, MA.Eng Thesis, Zhejiang University, China, 2007.
|
M. Bsiss, H. Ibrahim and A. Benaissa, “A quantified safety analysis for safety fuzzy logic controller 1oo2 reliability block diagrams”, ICCSCE 2012, 2012.
|
S. Du, “Improvement on safety redundancy structure considering both safety and reliability”, MA.Eng Thesis, Beijing Jiaotong University, China, 2019.
|
“IEC 61508 Functional safety of electrical/ electronic/programmable electronic safety -related systems”, International Electrotechnical Commission, 2010:21-62.
|
N. Kanekawa, “Potential of fault-detection coverage by means of on-chip redundancy-IEC61508: are there royal roads to SIL 4?”, IEICE Transactions On Information And Systems, Vol.E96D, No.9, pp.1907-1913, 2013.
|
X. Zhang, L. Xu, F. Ding and T. Hayat, “Combined state and parameter estimation for a bilinear state space system with moving average noise”, Journal of the Franklin Institute, Vol.355, NO.6, pp.3079-3103, 2018.
|
X. Zhang, F. Ding, F. Alsaadi and T. Hayat, “ Recursive parameter identification of the dynamical models for bilinear state space systems”, Nonlinear Dynamics, Vol.89, No.4, pp.2415-2429, 2017.
|
L. Kolek, M. Ibrahim, I. Gunawan, et al., “Evaluation of control system reliability using combined dynamic fault trees and Markov models”, IEEE. Proceedings of the 2015 IEEE 13th International Conference on Industrial Informatics, pp.536-543, 2015.
|
Y. Cao, Y. Zhang, T. Wen and P. Li, “Research on dynamic nonlinear input prediction of fault diagnosis based on fractional differential operator equation in high-speed train control system”, Chaos.https://doi.org/10.1063/1.5085397(online)
|
P. Gong, Y. Cao and B. Cai, “Multi-information location data fusion system of railway signal based on cloud computing”, Future Generation Computer Systems-The International Journal of Escience, Vol.88, pp.594-598, 2018.
|
Y. Cao, Y. Wen, W. Xu and X. Xie, “Directional beamforming for high-speed railway communications with frequency offset precorrectio”, Chinese Journal of Electronics, Vol.23, No.1, pp.163-168, 2014.
|
Y. Zhang, Y. Cao and Y. Wen, “Optimization of Information Interaction Protocols in Cooperative Vehicle-Infrastructure Systems”, Chinese Journal of Electronics, Vol.27, No.2, pp.439-444, 2018.
|
R. Pascoe and T. Eichorn, “What is communication based train control?”, IEEE Veh. Tech. Magazine, Vol.4, No.12, pp.16-21, 2009.
|
Y. Cao, W. Ma and L. Ma, “Local fractional functional method for solving diffusion equations on cantor sets”, Abstract and Applied Analysis, 2014,803693. http://dx.doi.org/10.1155/2014/803693.
|
P. Hokstad, “Demand rate and risk reduction for safety instrumented systems”, Reliability Engineering & System Safety, Vol.127, No.127, pp.12-20, 2014.
|
X. Zhang, F. Ding, L. Xu and E. Yang, “ State filtering-based least squares parameter estimation for bilinear systems using the hierarchical identification principle”, IET Control Theory and Applications, Vol.21, No.21, pp.1704-1713, 2018.
|
X. Zhang, F. Ding, L. Xu, A. Alsaedi and T. Hayat, “ A hierarchical approach for joint parameter and state estimation of a bilinear system with autoregressive noise”, Mathematics, Vol.7, No.4, pp.1-17, 2019.
|
Y. Wang, “Architecture design and security research of dual triple redundant fault tolerant system”, MA.Eng Thesis, Zhejiang University, China, 2015. (in Chinese)
|
Y. Lin, H. Lei, Y.Li, “Model checking of safety property over quantum Markov chain”, Acta Electronica Sinica, Vol.11, pp.2191-2197, 2014. (in Chinese)
|
L. Lu, Z. Kaymak and J. Brcsk, “The relationship between diagnostic coverage and proof test interval for 1oo2 and 1oo2D architectures”, IFAC Proceedings Volumes, Vol.45, No.24, pp.181-184, 2012.
|
M. Asadi and I. Bayramoglu, “The mean residual life function of a k-out-of-n structure at the system level”, IEEE Transactions on Reliability (S0018-9529), Vol.55, No.2, pp.314-318, 2006.
|