Volume 32 Issue 2
Mar.  2023
Turn off MathJax
Article Contents
LIU Yujie, WANG Yang, JIN Xiangliang, et al., “Analysis of Capacitance Characteristics of Light-Controlled Electrostatic Conversion Device,” Chinese Journal of Electronics, vol. 32, no. 2, pp. 389-396, 2023, doi: 10.23919/cje.2021.00.272
Citation: LIU Yujie, WANG Yang, JIN Xiangliang, et al., “Analysis of Capacitance Characteristics of Light-Controlled Electrostatic Conversion Device,” Chinese Journal of Electronics, vol. 32, no. 2, pp. 389-396, 2023, doi: 10.23919/cje.2021.00.272

Analysis of Capacitance Characteristics of Light-Controlled Electrostatic Conversion Device

doi: 10.23919/cje.2021.00.272
Funds:  This work was supported by the National Natural Science Foundation of China (61827812), Hunan Science and Technology Department Huxiang High-level Talent Gathering Project (2019RS1037), and Innovation Project of Science and Technology Department of Hunan Province (2020GK2018, 2019GK4016, 2020RC1003).
More Information
  • Author Bio:

    Yujie LIU received the B.E. degree in School of Information Engineering from Shaoyang University. He is now an M.S. candidate in the School of Physics and Electronic Science of Hunan Normal University. His research interest is new semiconductor power device design. (Email: 727805321@qq.com)

    Yang WANG received the Ph.D. degree in the School of Physics and Electronic Science, Hunan Normal University, Changsha, China. His research interests include high-voltage on-chip electrostatic discharge protection design

    Xiangliang JIN (corresponding author) received the M.S. degree in microtechnology with emphasis in electric circuits from Hunan University, Changsha, China, in 2000, and the Ph.D. degree in microelectronics and solid-state circuits with emphasis in CMOS image sensor design from the Institute of Microelectronics, Chinese Academy of Sciences, Beijing, China, in 2004. After graduation. He sets up Superpix Micro Technology Ltd. as one co-founder. From 2010 to 2017. He is a Full Professor in Xiangtan University. Now, he is a Full Professor in Hunan Normal University. (Email: jinxl@hunnu.edu.cn)

    Yan PENG received the Ph.D. degree in pattern recognition and intelligent systems from the Shenyang Institute of Automation, Chinese Academy of Sciences, Shenyang, China, in 2009. She is currently a Professor with Shanghai University, Shanghai, China, where she is also the Dean of the Research Institute of USV Engineering. She led the team to develop eight series of unmanned surface vessel, which were delivered to the State Oceanic Administration, Ministry of Transport, and other departments, and carried out missions in the East China Sea, Yellow Sea, and Antarctic. Her current research interests include ocean detection sensor modeling and control of unmanned surface vehicles, field robotics, and locomotion systems

    Jun LUO is currently a Professor with the Shanghai University, Shanghai, China, where he is also the Discipline Leader of mechanical engineering of Shanghai Plateau Disciplines, the holder of the National Science Fund for Distinguished Young Scholars, one of the Leading Talents of Shanghai, the Shanghai Subject Chief Scientist, the Shuguang Scholar, the holder of Shanghai Rising-Star Program (Follow-up), and the Vice Dean of the School of Mechatronic Engineering and Automation. He mainly works on the structure, sensing, and control technique of advanced robots

    Jun YANG received the B.S. and M.S. degrees from the Beijing Institute of Technology, Beijing, China, in 1998 and 2001, respectively, and the Ph.D. degree from University of Alberta, Edmonton, AB, Canada, in 2004. He is currently a Full-time Professor at the Institute for Advanced Study of the University of Electronic Science and Technology of China (Shenzhen), and the Center Director of Canada’s First Industry 4.0 R&D Center (WIN 4.0-Western’s Industry 4.0 Network). He has published more than 150 journal articles. His research interests include additive manufacturing/3-D printing, micro/nanofabrication, AI-based and Internet-based intelligent manufacturing, BioMEMS/RF-MEMS, metamaterials, printed electronics, sensors, flexible/wearable electronics, and THz technology

  • Received Date: 2021-08-02
  • Accepted Date: 2022-07-14
  • Available Online: 2022-08-04
  • Publish Date: 2023-03-05
  • In recent years, converting environmental energy into electrical energy to meet the needs of modern society for clean and sustainable energy has become a research hotspot. Electrostatic energy is a pollution-free environmental energy source. The use of electrostatic conversion devices to convert electrostatic energy into electrical energy has been proven to be a feasible solution to meet sustainable development. This paper proposes a light-controlled electrostatic conversion device (LCECD). When static electricity comes, an avalanche breakdown occurs inside the LCECD and a low resistance path is generated to clamp the voltage, thereby outputting a smooth square wave of voltage and current. Experiments have proved that LCECD can convert 30kV electrostatic pulses into usable electrical energy for the normal operation of the back-end light-emitting diode lights. In addition, the LCECD will change the parasitic capacitance after being exposed to light. For different wavelengths of light, the parasitic capacitance exhibited by the device will also be different. The smaller the parasitic capacitance of the LCECD, the higher the efficiency of its electrostatic conversion. This is of great significance to the design of electrostatic conversion devices in the future.
  • loading
  • [1]
    Chu S and Majumdar A, “Opportunities and challenges for a sustainable energy future,” Nature, vol.488, no.7411, pp.294–303, 2012. doi: 10.1038/nature11475
    [2]
    Debe M K, “Electrocatalyst approaches and challenges for automotive fuel cells,” Nature, vol.486, no.7401, pp.43–51, 2012. doi: 10.1038/nature11115
    [3]
    Guney M S, “Solar power and application methods,” Renewable and Sustainable Energy Reviews, vol.57, pp.776–785, 2016. doi: 10.1016/j.rser.2015.12.055
    [4]
    Morisson V, Rady M, Palomo E, et al., “Thermal energy storage systems for electricity production using solar energy direct steam generation technology,” Chemical Engineering and Processing: Process Intensification, vol.47, no.3, pp.499–507, 2008. doi: 10.1016/j.cep.2007.01.025
    [5]
    Kumar M S, Charanadhar N, Srikanth V V S S, et al., “Materials in harnessing solar power,” Bulletin of Materials Science, vol.41, no.2, pp.1–19, 2018. doi: 10.1007/s12034-018-1554-x
    [6]
    Siddiqui S, Kim D I, Roh E, et al., “A durable and stable piezoelectric nanogenerator with nanocomposite nanofibers embedded in an elastomer under high loading for a self-powered sensor system,” Nano Energy, vol.30, pp.434–442, 2016. doi: 10.1016/j.nanoen.2016.10.034
    [7]
    Deng W, Jin L, Chen Y, et al., “An enhanced low-frequency vibration ZnO nanorod-based tuning fork piezoelectric nanogenerator,” Nanoscale, vol.10, no.2, pp.843–847, 2018. doi: 10.1039/C7NR07325A
    [8]
    Rafique S, Kasi A K, Kasi J K, et al., “Fabrication of Br doped ZnO nanosheets piezoelectric nanogenerator for pressure and position sensing applications,” Current Applied Physics, vol.21, pp.72–79, 2021. doi: 10.1016/j.cap.2020.10.004
    [9]
    Liu D, Yin X, Guo H, et al., “A constant current triboelectric nanogenerator arising from electrostatic breakdown,” Science advances, vol.5, no.4, article no.aav6437, 2019. doi: 10.1126/sciadv.aav6437
    [10]
    Moon H, Chung J, Kim B, et al., “Stack/flutter-driven self-retracting triboelectric nanogenerator for portable electronics,” Nano Energy, vol.31, pp.525–532, 2017. doi: 10.1016/j.nanoen.2016.11.046
    [11]
    Han J M, Wang M, Tong Z M, et al., “Triboelectric nanogenerator based on graphene forest of electrodes,” Journal of Inorganic Materials, vol.34, no.8, article no.22, 2019.
    [12]
    Zhai L, Gao L, Wang Z, et al., “An energy harvester coupled with a triboelectric mechanism and electrostatic mechanism for biomechanical energy harvesting,” Nanomaterials, vol.12, no.6, article no.933, 2022. doi: 10.3390/nano12060933
    [13]
    Erturun U, Eisape A, and West J E, “Design and analysis of a vibration energy harvester using push-pull electrostatic conversion,” Smart Materials and Structures, vol.29, no.10, article no.105018, 2020. doi: 10.1088/1361-665X/aba5e2
    [14]
    Erturun U, Eisape A A, Kang S H, et al., “Energy harvester using piezoelectric nanogenerator and electrostatic generator,” Applied Physics Letters, vol.118, no.6, article no.063902, 2021. doi: 10.1063/5.0030302
    [15]
    Cheng G, Lin Z H, Du Z, et al., “Simultaneously harvesting electrostatic and mechanical energies from flowing water by a hybridized triboelectric nanogenerator,” ACS Nano, vol.8, no.2, pp.1932–1939, 2014. doi: 10.1021/nn406565k
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索

    Figures(9)  / Tables(1)

    Article Metrics

    Article views (2913) PDF downloads(43) Cited by()
    Proportional views
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return